discowhe.blogg.se - Hantek 1008c software espanol

The golden age of Spanish software ( Spanish: edad de oro del software español) was a time, between 19, when Spain became the second largest 8 bit computer entertainment software producer in Europe, only behind the United Kingdom. ( Learn how and when to remove this template message) ( November 2020) ( Learn how and when to remove this template message)

Please help improve it by rewriting it in an encyclopedic style. It is suggested to perform the Zero offset calibration and to use this instrument after few minutes that is on, when the temperature stabilize.This article is written like a personal reflection, personal essay, or argumentative essay that states a Wikipedia editor's personal feelings or presents an original argument about a topic. It drops fast after the device is turned on (even around 50mV on a scale of +-20V).

Zero offset on ADC is strongly temperature dependent.

Voltage Selector: the most reliable voltage selection is +/-20V, lower hardware voltages present strong non-linearity which make useless the full ADC range of the device (for example +/-500mV range is linear just in the range +500mV -> -80mV.

Acquisition: on each scan acquire 4000 bytes (2000 samples) from 2 buffers (2000 samples each buffer).

Drop down to 1.2MS/s if enable 2 channels.

Sample rate: maximum measured 2.4MS/s if just 1 channel is enabled.

A6 03 (acquire 64 bytes, 32 samples of 12 bits each, repeated 60 times get 2000 samples).

A6 02 (acquire 64 bytes, 32 samples of 12 bits each, repeated 60 times get 2000 samples).

Start of waiting cycle for data to be ready into the buffers

F3 -> hardware ping (required to send regularly also when acquisition is stoped, otherwise the hardware disconnect).

C1 00 00 for Channel 1, rising slope, C1 01 01 for Channel 2, falling slope)

C1 -> set trigger source and slope (ie.

AC 07 D0 00 03 42 00 03 42 set highest sampling rate for 2 channels enabled = 1.2MS/s)

A2 -> set voltage level for each channel (ie.

AA -> set which channel to enable (ie.

A0 -> set number of channel enabled (ie.Need to continuously send commands to the OUT Endpoint, and for each command receive the result from the IN Endpoint (both Endpoints can transfer max 64 bytes).The device got logically disconnected automatically if not receive any command after 7 seconds.